PED3 Steel Rotating Stand - Ease, Elegance & Secure

THREE TYPES:

We have three holders for you to select from, a bare iPhone, a bare iPod touch, or the FORM holder for any case, skin, or bumper-ed iPhone or iPod touch.

FIT:

The type of fit your holder has is up to you, some people like a tight secure fit and some people like a loose-drop in fit. Your initial use and setup with any holder you select may require a little adjusting to match your desired fit. If you select the larger FORM holder for instance, much more setup adjustment is allowed with it's design. The FORM holder design accommodates all cases, skins and bumpers including the Otterbox Defender, and Mophie Juice Pack Air case. 

INTERCHANGEABLE:

All of these holders are interchangeable with one another and can be used with our other PED3 and NAJA-King products. These holders are also available separately for you to make up any combination you would like.

iPhone or iPod touch - FORM holder
(Only works with a case, skin or bumper)*

SETUP OVERVIEW:

Your holder will need to be setup for your custom fit.  The holder is made of a high grade steel and protective finish that can tolerate the forming it takes to make your custom fit.

INSTRUCTIONS:

By hand you simply form the holder fingers for a loose or tighter fit as shown in the picture.  You may need to do this a few times to achieve your personal fit.

BASE

SOLID:

The weight of solid steel allows this product to have the lowest center of any iPhone or iPod stand

VIEW ANGLE:

The base allows for two angled viewing postions use the slip pin and grommet that will meet you needs wether you are standing at low coffee table or sitting at a high barstool. The positional grommets are industrial rubber and a replacable item, should you be an extreme user and need new ones.

STAYS PUT

In addition to the weight, there are four non skid non slip polyethylene feet to keep the stand planted where you put it.