Loading... Please wait...
  • Image 1
  • Once configured the Alloy Fingers allow just the right amount of grip for easy in, and easy out of the holder functionality.

PED4 Alloy Finger Kit & Tool

$3.99
Rating:

Product Information

New Alloy Finger Material

  • Stronger alloy material
  • Stronger alloy threads
  • Higher temperature alloy
  • Protective vinyl cover

Replacement alloy fingers for PED4 product line and a great upgrade for previous PED4 living finger owners.

ITEMS INCLUDED:

  • 3 protective vinyl covered alloy fingers with screws
    • Note for iPad and iPad mini: 2 kits are required for full replacements, a total of 6 fingers.
  • 5/64" torque limiting wrench (tool)

 

Replacement PED4 CH Allloy Guides can be found here

PED4 Extension Living Fingers can be found here

 

INSTRUCTIONS FOR ADJUSTING HOLDERS WITH EXISTING ALLOY FINGERS IN PLACE (NEW PRODUCTS):

Do not remove the alloy finger from the holder, only do so if necessary, for instance due to replacement installation. (see below for instructions) 

Using the limiting torque wrench provided with your holder, it is important to not over torque the alloy finger. While looking at the screw it is important to LOOSEN the screw only a quarter of a turn COUNTER CLOCKWISE, make your adjustment by sliding the alloy finger in the slot, and then using the supplied limited torque wrench, turn the screw CLOCKWISE LIGHTLY to TIGHTEN. The amount of torque to hold the alloy finger in place is very minimal.

Never use a standard allen or hex key as too much force created from these tools may strip the threads in the alloy finger.

 

INSTRUCTIONS FOR INSTALLING ALLOY FINGERS:

With the worn living or alloy finger removed, place the new alloy finger in the slot with the screw removed, and hold in place with your finger in one hand. With you opposite hand, roughly place the screw in the slot on the opposite side of the alloy finger. It does not have to be in the screw hole yet, grab with your opposite hand the limiting torque 5/64" hex key wrench (small tool) and match up to the screw head. From here it should be very easy to find the screw hole while turning the wrench CLOCKWISE and LIGHTLY TIGHTEN with the alloy finger in the closed position. Now complete as necessary in other locations. Once all alloy fingers are replaced, you can then move on to the next procedure of configuring it to your bare or cased device.    

While looking at the screw it is important to LOOSEN the screw only a quarter of a turn COUNTER CLOCKWISE, make your adjustment by sliding the alloy finger in the slot, and then using the supplied limited torque wrench, turn the screw CLOCKWISE LIGHTLY to TIGHTEN. The amount of torque to hold the alloy finger in place is very minimal.

Never use a standard allen or hex key as too much force created from these tools may strip the threads in the alloy finger.

 

Product Reviews

Write your own product review

  1. Better Than Previous Fingers 4 Star Review

    Posted by on 10th Aug 2015

    These are certainly better than the previous plastic fingers that all broke apart when adjusted to fit your phone. The "tale of the tape" will be if they last day after day of inserting and removing your phone in the holder.


Videos

PED4 Alloy Finger Explanation & Proper Use (01:47)
How to properly use the PED4 Alloy Finger http://www.thoughtout.biz/ped4-alloy-finger-kit-tool/
  • PED4 Alloy Finger Explanation & Proper Use
    How to properly use the PED4 Alloy Finger http://www.thoughto...

Find Similar Products by Tag

CH50  CH60  CH61  IPA10  IPM10  

Find Similar by Category